Sparkeys Stock showcase

[Sparkey98]

Thank you badnik
I did what you said, now it's a MW

[Badnik96]

Give it Plastic.

[Sparkey98]

Ok, thank you!

[ianh05]

you don't need T connectors for that setup you can use 4 round extenders and save 2kgs.
_____ <-- 2 extenders, your 2 RAD's go here.
    |      <-- 1 extender
-----      <-- 1 extender, your plow gets connected here.

surely you can figure it out :P

[Gazea2]

Sparkey, you are definitely getting better. Now take ian's advice or you could make it more generic and use a snapper II.

[Daemon]

Ok, thank you!
(Image removed from quote.)

Not bad

[Sparkey98]

Not trying to be my self again but what difference would it make?

@Daemon thanks

[Sparkey98]

[Noodle]

You could prolly make that a middleweight.  Lower the chassis (6 pixels above the lowest height limit) so that it's just tall enough for the HP Zteks, use DSA, and try to make the right snapper more useful.

[Somebody]

You don't need the second snapper for the ramplate. Move the HPZ out of the way, and then you can attach it using a baseplate connector.

Also, turn the irons vertical so both hit at the same time.

[090901]

You could prolly make that a middleweight.

It is a middleweight.

[Noodle]

You could prolly make that a middleweight.

It is a middleweight.

Oh crap I was thinking 250 kilos was middleweight (I don't know why either).

Anyway, still helps to reduce weight to add more stuff.

[Natef]

Replace the ramplate with a plow.

[Somebody]

Build to the weight limit!

[Pwnator]

You don't need the second snapper for the ramplate. Move the HPZ out of the way, and then you can attach it using a baseplate connector.

Also, turn the irons vertical so both hit at the same time.

[TorrFac]

You don't need the second snapper for the ramplate. Move the HPZ out of the way, and then you can attach it using a baseplate connector.

Also, turn the irons vertical so both hit at the same time.

baseplate don't fit in this chassis unless to redo whole bot thought...snapper II have 2 attachment points....other is from the side. attach ramplate to that point

[G.K.]

Have you ignored everything we told you before?

[Somebody]

The baseplate will fit perfectly fine if the SnapperII fits.

Also, with the weight left over, you can eFFe a third spike onto each part.

[TorrFac]

The baseplate will fit perfectly fine if the SnapperII fits.

Also, with the weight left over, you can eFFe a third spike onto each part.

it will be 4 kg's heavier...

[Sparkey98]

Have you ignored everything we told you before?

Me or Torrfac?