Components on Snappers Glitching with Floor

[Lightning S.]

I've been trying to edit the starting points of an arena and everything has mostly been going fine, but any components on snappers too close to the ground seem to glitch for some reason. Even weirder, this only happens in ports 1 and 4; 2 and 3 are perfectly fine.

Code: [Select]

*GMID_ATTACHMENTPT
{
*NODE_NAME Startpoint 1
*NODE_TM
{
*NODE_NAME Startpoint 1
*TM_ROW0 -1.000000 0.000000 0.000000
*TM_ROW1 0.000000 1.000000 0.000000
*TM_ROW2 -0.000000 0.000000 -1.000000
*TM_ROW3 10.000000 0.300000 10.000000
}
USER DATA type = startpoint
id = 1

}
*GMID_ATTACHMENTPT
{
*NODE_NAME Startpoint 2
*NODE_TM
{
*NODE_NAME Startpoint 2
*TM_ROW0 1.000000 0.000000 0.000000
*TM_ROW1 0.000000 1.000000 0.000000
*TM_ROW2 0.000000 0.000000 1.000000
*TM_ROW3 -10.000000 0.300000 -10.000000
}
USER DATA type = startpoint
id = 2

}
*GMID_ATTACHMENTPT
{
*NODE_NAME Startpoint 3
*NODE_TM
{
*NODE_NAME Startpoint 3
*TM_ROW0 1.000000 0.000000 0.000000
*TM_ROW1 0.000000 1.000000 0.000000
*TM_ROW2 0.000000 0.000000 1.000000
*TM_ROW3 10.000000 0.300000 -10.000000
}
USER DATA type = startpoint
id = 3

}
*GMID_ATTACHMENTPT
{
*NODE_NAME Startpoint 4
*NODE_TM
{
*NODE_NAME Startpoint 4
*TM_ROW0 -1.000000 0.000000 0.000000
*TM_ROW1 0.000000 1.000000 0.000000
*TM_ROW2 -0.000000 0.000000 -1.000000
*TM_ROW3 -10.000000 0.300000 10.000000
}
USER DATA type = startpoint
id = 4


Anyone know what's going on here?

[Mr. AS]

likely either

a) You pressed pause before starting the match
b) The Y value of your start point is too low
c) The robot you built has snapper arms reaching too far down (not likely)

[Lightning S.]

Thanks, raising the y value seemed to solve most of the problems.