Author Topic: Gaz's Garage (Read 99534 times)

Pwnator · « **Reply #820 on:** October 03, 2011, 05:11:44 AM »

Quote from: Naryar on October 03, 2011, 05:03:34 AM

Anyways, a nifty can power this bot yeah, but it's batteries will be flat after two minutes.

As if 4 irons will last two minutes. :P

smashysmashy · « **Reply #821 on:** October 03, 2011, 10:01:09 AM »

Quote from: Naryar on October 03, 2011, 05:03:34 AM

Quote from: smashysmashy on September 28, 2011, 11:40:36 AM
Quote from: Virus Bomb on September 27, 2011, 06:40:09 PM
lose the black for a nifty.

Nifty = 2 HPz
Black= 4 HPz

Would it be best to make it underpowered for more weight?

I honestly don't know

Because I am a n00b and I can't even stack :D

Smashy, just DON'T POST if you can't give good advice. Kthx.

Anyways, a nifty can power this bot yeah, but it's batteries will be flat after two minutes.

Fine the only contributions I will make will now be negative.

My point was it would be fully powered for three minutes with a black, and not if it was a nifty.

Looks like its probably best if I stop contributing at all...

ty4er · « **Reply #822 on:** October 03, 2011, 10:05:17 AM »

dont baww, just don't give out false advice.

Gazea2 · « **Reply #823 on:** October 03, 2011, 01:13:47 PM »

Nifty + razors + two casters

Made this three months ago. 4 FS' and two HS'. Two blacks and a massive wedge.

NFX · « **Reply #824 on:** October 03, 2011, 01:27:43 PM »

Casters should ideally be mounted out the sides of the chassis, to prevent HS getting any hits in. But looks not too bad nonetheless.

MW/FS looks suitably mad. It looks a bit too long and narrow for my liking, however, I'm sure you could attach the motors above the Snapper2 to save some space and improve turning.

Gazea2 · « **Reply #825 on:** October 03, 2011, 01:32:03 PM »

Quote from: NFX on October 03, 2011, 01:27:43 PM

Casters should ideally be mounted out the sides of the chassis, to prevent HS getting any hits in. But looks not too bad nonetheless.

MW/FS looks suitably mad. It looks a bit too long and narrow for my liking, however, I'm sure you could attach the motors above the Snapper2 to save some space and improve turning.

Yeah, I tried to put them on the edges but it wouldn't let me stack them in. I'll try later.

I'm not sure what the

I was thinking on the HW. Everything I build is long and narrow. XD
I could probably cut down on the length but I like how stupidly crazy it is. :D

Gazea2 · « **Reply #826 on:** December 11, 2011, 12:04:16 PM »

Gaz casts bumpaga!
Just getting back into RA2. Don't expect anything special.

2 blacks, DSA.. The usual. Slightly underweight but I'm not sure what to spend it on. Armour would probably help but I'm not sure where to place it.

Mr. AS · « **Reply #827 on:** December 11, 2011, 12:11:06 PM »

Quote from: Gazea2 on December 11, 2011, 12:04:16 PM

Armour would probably help but I'm not sure where to place it.

Anchor ---> 20-60 cm extender ---> Ramplates/snowplows
right in the center
below the exposed ddt

Jonzu95 · « **Reply #828 on:** December 11, 2011, 12:57:39 PM »

More armour. Ramplates or Plows to front.

Sage · « **Reply #829 on:** December 11, 2011, 06:06:39 PM »

Just extend the front and add some castor armor.

Naryar · « **Reply #830 on:** December 11, 2011, 06:59:24 PM »

needs armor !

(what Sage said)

Gazea2 · « **Reply #831 on:** December 12, 2011, 11:28:37 AM »

789.5.

That Robot is a Spy! · « **Reply #832 on:** December 12, 2011, 11:40:31 AM »

Quote from: Gazea2 on December 12, 2011, 11:28:37 AM

(Image removed from quote.)

789.5.

Get another caster in the middle.

Jonzu95 · « **Reply #833 on:** December 12, 2011, 12:17:48 PM »

Why the useless square extender?

Gazea2 · « **Reply #834 on:** December 12, 2011, 12:18:14 PM »

To aid with self-righting. It's the super long one.
inb4QOOC

Gazea2 · « **Reply #835 on:** December 12, 2011, 12:40:37 PM »

I'm loving these curved hammers.

NFX · « **Reply #836 on:** December 12, 2011, 01:25:38 PM »

Looks pretty good. I may shrink up the chassis a tiny bit at the back, and try to get some protection on the front somehow. It looks a bit exposed for my liking at the moment.

Fracture · « **Reply #837 on:** December 12, 2011, 04:07:36 PM »

Less weight on weapon system, more weight on a wedge or casters.

smashysmashy · « **Reply #838 on:** December 12, 2011, 04:09:08 PM »

I think what's been needed to say has been covered.

I like it =D

Naryar · « **Reply #839 on:** December 12, 2011, 05:47:14 PM »

2 DDT's for a MW side hammer is overkill.

May want to add a wedge and more weapons, and maybe reduce the drive as well to normal Zteks.