Author Topic: Tweedy's Beetleweight Stuff (Read 44247 times)

Tweedy · « **Reply #20 on:** October 10, 2011, 01:25:09 PM »

2nd idea :

haz · « **Reply #21 on:** October 10, 2011, 01:32:43 PM »

what do you mean buy sharp edges, its plastic so it wont be sharp

Tweedy · « **Reply #22 on:** October 10, 2011, 01:37:59 PM »

i meant the edge for a decent wedge

haz · « **Reply #23 on:** October 10, 2011, 01:43:54 PM »

nick some of those lamanating sheets of thin plastic and then put that on the polycarbonate for 0mm ground clearence

Tweedy · « **Reply #24 on:** October 10, 2011, 01:45:02 PM »

thanks

haz · « **Reply #25 on:** October 10, 2011, 01:49:23 PM »

best to replace them after spinners get to them though

Tweedy · « **Reply #26 on:** October 10, 2011, 01:58:01 PM »

it shouldnt be going up against any spinners because i only plan on entering roaming robots because theres nowhere to fight it near me

haz · « **Reply #27 on:** October 10, 2011, 02:02:00 PM »

well antweight events move around a lot more than roaming robots

Tweedy · « **Reply #28 on:** October 10, 2011, 02:04:00 PM »

could you send me the links to some of them please because the next roaming robots close to me is in november

haz · « **Reply #29 on:** October 10, 2011, 02:06:08 PM »

there arent many as its the end of the year (ish)
aws bristol
atc oxfordshire

Tweedy · « **Reply #30 on:** October 10, 2011, 02:19:04 PM »

I'll have to start entering it regularly next year then because im nowhere near bristol or oxfordshire

SKBT · « **Reply #31 on:** October 10, 2011, 02:21:27 PM »

Quote from: plazmic inferno on October 10, 2011, 01:25:09 PM

2nd idea :

This is probably the better design.

Tweedy · « **Reply #32 on:** October 10, 2011, 02:27:24 PM »

how would i get the good edge for the wedge though because i was going to bend it and sand it down but is there a way i could attach two pieces together to make a good wedge ?

haz · « **Reply #33 on:** October 10, 2011, 03:20:40 PM »

why sand it down?

Tweedy · « **Reply #34 on:** October 10, 2011, 03:23:07 PM »

to try and get a straight edge

haz · « **Reply #35 on:** October 10, 2011, 03:33:17 PM »

on polycarb? scissors seem to cut it pretty staight

Tweedy · « **Reply #36 on:** October 10, 2011, 03:36:00 PM »

i meant like the lip on the wedge

haz · « **Reply #37 on:** October 10, 2011, 03:43:16 PM »

with a 1mm material there isnt much point, its easyer to put paper or thin plasitc on the front instead

Tweedy · « **Reply #38 on:** October 10, 2011, 03:46:19 PM »

ok thanks i'll just do that then

Tweedy · « **Reply #39 on:** October 25, 2011, 05:22:52 PM »

just signed up for roaming robots at maidstone and I'm getting my antweight there from haz so it will be my first time driving it. fingers crossed i dont get annihalated