This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Philippa
6322
« on: August 05, 2011, 08:26:13 AM »
2 normal NPCs, 2 BSGs and 6 ants 
6323
« on: August 05, 2011, 06:31:39 AM »
Latest version 
6324
« on: August 05, 2011, 06:07:26 AM »
Ok here is the new one. It's now a Lightweight. I know that i was told to have a 2WD with NPC fasts and Hypno-Disc's wheels but i didn't cos something went wrong with the FastRight one not the FastLeft a while after I made Zuton. I did use NPC Fasts but I had to use them upright. 
6325
« on: August 05, 2011, 05:45:39 AM »
Next bot is Flying Physics. NO cheatbot2 stuff. MW rating, has 4 stacked Ants for power, and has 3mm aluminium armour. Tips welcomed. Flying Physics is a bot that I just made in the last 10-15 minutes and is my attempt at aking a physics powered flipper. I think the shaft is a bit too long but I haven't sorted it out yet. I got the idea from watching a vid on YouTube by CourtHouseDoc and one of his bots was like that.  
6326
« on: August 05, 2011, 05:08:47 AM »
Ok. Yours look pretty cool. Especially that vertical double drum one. My bot 2 or something? Cant remember the name...
6327
« on: August 05, 2011, 04:59:00 AM »
Cheers Ashman
6328
« on: August 05, 2011, 04:34:01 AM »
6329
« on: August 05, 2011, 04:25:40 AM »
The funny part in this is that in the Hot Wheels movies, the character Kurt Wylde was an arrogant, cocky asshole.
Please stop trying to be like him.
I'm not trying to be like him.
6330
« on: August 04, 2011, 03:55:40 PM »
yay
6331
« on: August 04, 2011, 03:51:51 PM »
Yeah. Those will be needed, and what arena did you use.
robot wars arena
6332
« on: August 04, 2011, 03:51:23 PM »
ok i have closed it down but i can say that it had 4 or 5 e-teks powering the spinners
6333
« on: August 04, 2011, 03:47:20 PM »
Just beat the SHW face spinner from 123AI threw it oota about halfway through the match. Nothing came off Zuton but 1 motor began to smoke
6334
« on: August 04, 2011, 03:11:51 PM »
6335
« on: August 04, 2011, 03:03:42 PM »
6336
« on: August 04, 2011, 03:02:47 PM »
The motor and armour choice is pretty good, and the wheelguards are also quite well done. You should try using Techno Wheels with the weight allowance, but Judge Bursts are cheatbot2 parts, and hence are not allowed in standard DSL, and Long batteries are the single worst battery choice you can make. EVERY spin motor requires one ant battery to work, so this would need 8 ants to drive. Also, you should try to use the larger CB when you can, because it's actually lighter.
I put the Rubber Wheels on cos then I wouldn't have very much ground clearance on either side and also if i had used Techno Destructo's wheels then it would be quite high off the ground and there would be the risk of overhead attacks cos they're so wide, and if I put protection over the top of them then they wouldn't be able to make Zuton run inverted... Also, about the Control Board choice, a kilo or two (depending on which one you pick) isn't gonna make a lot of difference cos when it goes to UHW it is kinda like unlimited weight from then on. If I had just 8 Ants for power then it would begin to wear down really fast... Wouldn't it? Thanks for the advice btw.
6337
« on: August 04, 2011, 02:41:09 PM »
Here is the first robot I have ever made that has used an anti-ballast so I could make SHWs and UHWs. It is called Zuton and it has a flipper powered by 3 Judge Burst Motors with a Tazbot Weapon as the flipping arm. It has 10mm steel armour and is invertible but can also self-right using the flippers.  
6338
« on: August 04, 2011, 02:31:55 PM »
robutts ahead
6339
« on: August 04, 2011, 04:17:36 AM »
6340
« on: August 03, 2011, 03:15:14 PM »
I did have a bot to enter but my DSL-TC crashed so I'm still trying to figure out how to get it working again...
|
Show Posts
