This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pwnator
4021
« on: July 25, 2010, 01:27:42 AM »
Yarp.
4022
« on: July 25, 2010, 01:27:17 AM »
Snapper loading. That's also the reason I was able to have intersecting HP-Zteks in the drive.
4023
« on: July 25, 2010, 01:20:38 AM »
Here's how to get 4:
DDT -> extender straight out with attachment points (APs, for short) facing one side (1 RAZOR) -> extender out from the outermost side AP (2 RAZORS) + using the side AP of this extender, attach it to the remaining side AP of your main extender (1 RAZOR)
And stacking batteries is a bit frustrating at the start, but you'll get used to the time-consuming activity once you use it a lot. XD
4024
« on: July 25, 2010, 01:07:09 AM »
You could try out the Pyscolone popup challenge. A MW with 2 HP-Zteks + rubbers, 2 stacked blacks, 1 wedge DDT, 2 weapon DDTs with 4 razors each.
:D
4025
« on: July 25, 2010, 12:56:05 AM »
Very nice. Since you have free weight, you should lengthen your wedges by another 20cm and make your chassis wedge shallower. :D
4026
« on: July 24, 2010, 11:02:58 PM »
To amp it up to a HW, you'll just need to add lots of external front armor (you'll need snapper loading and eFFeing for that).
Trimming it down to a MW seems easier. Just get rid of a weapon DDT and shrink the chassis. :D
4027
« on: July 24, 2010, 10:53:52 PM »
Had.
4028
« on: July 24, 2010, 10:31:10 PM »
You can rip off my chassis from the Synchotrons team (IIRC all the bots have the same core setup). You could probably use tite 1 on my chassis. Not sure, though. XD
4029
« on: July 24, 2010, 10:23:43 PM »
You're back! :D
Anyways, your first job is to upgrade your drive to HPZs. You can squeeze out the weight if you reduce the chassis space a little. :D
4030
« on: July 24, 2010, 10:16:30 PM »
Fight 2:No Hype wins by OOTA
NO WAI :O
4031
« on: July 24, 2010, 11:08:11 AM »
Casters. That's what I did on Fission. XD
4032
« on: July 24, 2010, 10:52:59 AM »
That's the essence of bursted setups. I'll try a single-wedged static setup to see if I can be more successful with that. :D
4033
« on: July 24, 2010, 10:08:49 AM »
NPCF+Hypno+Perm 80 combo makes it glitch out on occasions (unlike NPC+Techno combo, which will always glitch out).
As for the HP problem, I've never encountered that on my bots, but try this: main extender -> 20x40 bar with APs facing sides -> Mag attached on side AP (the one that can't be hit by bots) -> weapon setup. This might work.
4034
« on: July 24, 2010, 09:40:33 AM »
The backwards are now diamonds.
4035
« on: July 24, 2010, 09:35:05 AM »
SnSnS 3 didn't do much ass-kicking. It gently nudged my bot into OOTA-age. :P
And of course it spins faster. Slims are drive motors. :P
You should have at least Mags for this. If Nary and I were able to put Perms on ours, so can you. :P
4036
« on: July 24, 2010, 09:14:04 AM »
More than 60kgs on a piglet?
WAT
4037
« on: July 24, 2010, 07:17:59 AM »
Mini wheels are heavier than shines, so no.
4038
« on: July 24, 2010, 07:01:08 AM »
Should be, but can't. :P
4039
« on: July 24, 2010, 06:57:27 AM »
4040
« on: July 24, 2010, 03:35:50 AM »
Since I suck at stock pokers, I should practice building them more often ahahahahaha  DSA, 1 tank, 2 pinks, everything's on 2 blue snappers. Just wanted to build a wedged RoAcH. To my surprise, it's actually not that bad. XD
|
Show Posts
