Author Topic: Motor idea  (Read 1176 times)

Offline Zana

  • Antweight
  • Posts: 36
  • Rep: 0
    • View Profile
    • http://www.freewebs.com/zanasworldofra2
    • Awards
Motor idea
« on: July 07, 2008, 09:15:27 PM »
Does every one know how one RA1 they would have those saws would go so slow and come in well i would like motors like that that would move on an axis slowly so you for example could put a slow servo motor on then extender then one of these motors then an extender then i could make an arm off the bot so i could attack from every side with one weapon not put on multiple weapons...
so i want it to be the base of the motor for the saw on ra1 but in ra2 :) this would be good for the dsl mod :-D
I will make components for you just go to my topic: check this out DO IT!!!!!!!
and
[SIGPIC][/SIGPIC]

Offline RA2lover

  • Antweight
  • Posts: 114
  • Rep: 0
  • Not-so-active-guy
    • View Profile
    • Awards
Motor idea
« Reply #1 on: July 08, 2008, 06:59:09 AM »
Not exactly. In RA1, saws did MOST damage, but they did break too fast. also, RA1 did not had horizontalspinners to fend off em.

Slow servos would be good, but impractical during combat. before you can move the arm itself away, the arm is.... GONE!

this way, DSL servos are good as it is. they just need

1-Arc Limitation
2-Drum-ish axle to avoid side connections
3-A lil less torque, since i can use them well as HW shuffler drive motors, without damaging that much as spin motors.

Offline Zana

  • Antweight
  • Posts: 36
  • Rep: 0
    • View Profile
    • http://www.freewebs.com/zanasworldofra2
    • Awards
Motor idea
« Reply #2 on: July 17, 2008, 08:50:22 PM »
I rather have them faster and dont break the ra1 saws sucked but rocked at the same time...

Quote from: RA2lover;10693
Not exactly. In RA1, saws did MOST damage, but they did break too fast. also, RA1 did not had horizontalspinners to fend off em.

Slow servos would be good, but impractical during combat. before you can move the arm itself away, the arm is.... GONE!

this way, DSL servos are good as it is. they just need

1-Arc Limitation
2-Drum-ish axle to avoid side connections
3-A lil less torque, since i can use them well as HW shuffler drive motors, without damaging that much as spin motors.
I will make components for you just go to my topic: check this out DO IT!!!!!!!
and
[SIGPIC][/SIGPIC]