gametechmods
Robot Arena => Discussion => Topic started by: hazardpuss on August 26, 2016, 12:44:09 PM
-
Like any good newb I looked up info on how to make robots properly. One of the things people mentioned was using extenders, but I have a problem. How do I know how much I am rotating the round face of the extender? As far as I can tell it is featureless.
Also would it be possible to re-skin the extenders to show where the attachment points are?
-
Stock extenders are hexagon-shaped, so if you look closely you can see it rotating. What I usually do is put on the extender without rotating at all to see which way the attachment point is going. Then I remove that extender, and put a new extender, rotating the second one to the relevant position.
Alternatively, you could try out DSL or Ironforge, both of which have square extenders with attachment points on all sides, so it's way less of a pain.
I think there is a skin pack or something that adds a mark to the proper side of the extender, but I donno where it is.
Good luck!
-
I think there is a skin pack or something that adds a mark to the proper side of the extender, but I donno where it is.
Sage's skin pack it only works for red extender though
-
I think there is a skin pack or something that adds a mark to the proper side of the extender, but I donno where it is.
https://gametechmods.com/forums/index.php?topic=16351.0
-
i put it on the red extender so i'd know who the newbs are
-
Ok so I discovered that if you alternate which end you attach from it always has the connectors on the same side. also thank you