Gaz's Garage

[R0B0SH4RK]

Actually, I thought of a different setup but it will look totally different. XD

Well that's not only descriptive and informative, but helpful too!
 
This isn't Twitter. You have more than 140 characters to tell us what you're thinking xD

[Gazea2]

LOL XD

Any tips on my bots, R0B0?

[Gazea2]

DP!

Here is a new bot:



It is another lightweight for my team, Spinners From The East.

[Gazea2]

*Cricket chirps* O_O

[Gazea2]

TP!?

Here is my finished team for my pack:



 

[ianh05]

the weapon motor on the HP series bots look exposed any way that you can fix that? also screenshots of spin cycle please or link to it in your showcase, hard to tell what it is from that pic (looks like a dual FS).

Stock Showcase section is so quite >.>

[Sage]

That LW design has been done and redone so much, people get tired of commenting on them.

Team looks fine. Good job.

[Gazea2]

I know about the lightweight. I'm going to lengthen the extender for the plow.

I'll get a screenie of the other lightweight as well.

@Sage - Thanks for the compliment. :D

[R0B0SH4RK]

Most of the stuff has already been mentioned here, so I can't think of any specific advice right now...
To me, it looks like you're on the right track. Ruiner and HP Mace Tek look like two of my earlier bots xD
I'd like to see more of Vortex though.

[Gazea2]

Here is Vortex:

^Ok, I'll check.^

Here is the first heavyweight for my first team, Spinners From The East:

(Image removed from quote.)

I just have to skin the grannies and iron spikes.

EDIT: I just realised that there aren't any inside pics. >_<

[Pwnator]

Actually, I thought of a different setup but it will look totally different. XD

Well that's not only descriptive and informative, but helpful too!
 
This isn't Twitter. You have more than 140 characters to tell us what you're thinking xD

That's because I still can't help much if I can't think of a setup that makes it look similar to his. All I could think of was double-snapper setups. I still haven't found a decent single-snapper setup that makes it invertible. :P

[Gazea2]

Mine is invertible.

[Gazea2]

DP!

Here is a new bot:



It's not finished yet but I'm going to add a few castors on the front, tilt the weapon motors a bit and add some more weapons. Comments?

[JoeBlo]

reminds me very much of my old robot Circus

the weapon motors may need to be mounted lower to get robots ontop.. otherwise it would probably knock them away

[Somebody]

Higher plow.

[Gazea2]

Here is the updated version:



Not sure what to do with the weight.

[FOTEPX]

I refer you to Badnik's CT. Other than that, looks sweet. The scoop at the back might be a bit too high, making the Extender vunerable if they clear your weapons.

[Gazea2]

Here is the updated version:

*Pic*

Not sure what to do with the weight.

[NFX]

4 maces on each disk instead of 2 and 2, possibly more casters on the front.

If you can, what I'd do is try and get a third wedge inbetween the other two, 'cause one long wedge will get under you easily.
 
[offtopic] 1111 posts lol. [/offtopic]

[Sage]

Wayyyy to high center of gravity. Put the motors and the plow DOWN, and maybe extend the wedges.