Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Manic_Eraser_Cat

Pages: [1]
1
Thanks, I had it set on medium, and setting it to low fixed it easily.

2
That's what I've been doing, but there are only 3 things that match the coordinates in the bot file, and replacing all makes no difference

3
Do you know where this second mesh is? There are only 3 instances where I find the coordinates of a point, which represents the 3 meshes a single point has.

4
General Support / Re: Damaged AI
« on: June 30, 2019, 09:44:43 PM »
Only way I can think of is to lower the quality settings, which stops dents from appearing when damage is done to the chassis when put at the lowest level

5
DSL 2.2 - Good Robottal's 2018 Battlebots Pack
When I BFEd a chassis, it worked fine and in the bot lab, it displayed correctly. However in the testing arena, not only did the BFE not make a difference to its appearance, but the mesh acted as if the chassis was tweaked, like in the bot lab.

 
4t.png

 
4u.png

6
General Support / Re: Can't open up .bot files in Notepad++
« on: June 29, 2019, 10:27:10 PM »
Thanks boss. 183,628 lines of pp later and I've found the normal stuff. Even made a new bot without a picture and it didn't have the black stuff in it.

7
General Support / Can't open up .bot files in Notepad++
« on: June 29, 2019, 10:06:04 PM »
Every time I open up a .bot file to BFE it I always end up with a bunch of crap that I can't properly edit. Any fixes?

Pages: [1]