1
General Support / Re: BFEing the chassis works fine in Bot Lab, doesn't in Testing
« on: July 08, 2019, 11:11:19 AM »
Thanks, I had it set on medium, and setting it to low fixed it easily.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
General Support / Re: BFEing the chassis works fine in Bot Lab, doesn't in Testing« on: July 08, 2019, 11:11:19 AM »
Thanks, I had it set on medium, and setting it to low fixed it easily.
2
General Support / Re: BFEing the chassis works fine in Bot Lab, doesn't in Testing« on: July 07, 2019, 08:55:52 PM »
That's what I've been doing, but there are only 3 things that match the coordinates in the bot file, and replacing all makes no difference
3
General Support / Re: BFEing the chassis works fine in Bot Lab, doesn't in Testing« on: July 07, 2019, 06:56:33 PM »
Do you know where this second mesh is? There are only 3 instances where I find the coordinates of a point, which represents the 3 meshes a single point has.
4
General Support / Re: Damaged AI« on: June 30, 2019, 09:44:43 PM »
Only way I can think of is to lower the quality settings, which stops dents from appearing when damage is done to the chassis when put at the lowest level
5
General Support / BFEing the chassis works fine in Bot Lab, doesn't in Testing« on: June 29, 2019, 11:24:36 PM »
DSL 2.2 - Good Robottal's 2018 Battlebots Pack
When I BFEd a chassis, it worked fine and in the bot lab, it displayed correctly. However in the testing arena, not only did the BFE not make a difference to its appearance, but the mesh acted as if the chassis was tweaked, like in the bot lab. 6
General Support / Re: Can't open up .bot files in Notepad++« on: June 29, 2019, 10:27:10 PM »
Thanks boss. 183,628 lines of pp later and I've found the normal stuff. Even made a new bot without a picture and it didn't have the black stuff in it.
7
General Support / Can't open up .bot files in Notepad++« on: June 29, 2019, 10:06:04 PM »
Every time I open up a .bot file to BFE it I always end up with a bunch of crap that I can't properly edit. Any fixes?
Pages: [1]
|