gametechmods

Robot Arena => Showcases => Ironforge TC Showcases => Topic started by: Hoppin on October 27, 2017, 02:49:22 PM

Title: Hoppin's Robots that are IronForge
Post by: Hoppin on October 27, 2017, 02:49:22 PM
So I decided to try IronForge, did some lurking particularly with Reier & Lightning's showcases

Riptilion. St10
 [ This attachment cannot be displayed inline in 'Print Page' view ]
 [ This attachment cannot be displayed inline in 'Print Page' view ]
Title: Re: Hoppin's Robots that are IronForge
Post by: Reier on October 27, 2017, 04:03:31 PM
looks like a tough sucker. st10 is not necessarily a waste in IF like it is in DSL (since the chassis armor is tougher here) but there may be better things to use it on.
the main thing I'm concerned about is its lack of invertibility though. I know it'll be a pain to figure out a solution with your weapon system but it's needed honestly. without changing anything major, a system that might work is to give it tracks and attach a few ~60cm extenders to the top of your hex plates. your weapon won't hit squat when youre inverted but it's better than being immobilized.

your wedge will also probably be pretty weak with that setup. I recommend two medium angled skirts as far apart as you can put them on.

other than that, it looks pretty solid. I would recommend from personal experience to shove a couple of ballasts in there just so it doesn't get knocked around as much and amp up the grip on your wheels a bit to compensate. with st10 you should have plenty of weight.
Title: Re: Hoppin's Robots that are IronForge
Post by: Hoppin on October 27, 2017, 05:49:13 PM
Ok so I fixed the wedge. I also noticed after testing invertability that it's still able to drive which is cool but I'll see if I can fix something regarding the blades, was trying something with angled tracks but it tilted back when I reverse. Oh and it runs Ti10

 [ This attachment cannot be displayed inline in 'Print Page' view ]
Title: Re: Hoppin's Robots that are IronForge
Post by: Hoppin on March 04, 2018, 11:04:16 AM
IF GTMCS Entry

Competitive IRL :Heck:

 [ This attachment cannot be displayed inline in 'Print Page' view ]
 [ This attachment cannot be displayed inline in 'Print Page' view ]
Title: Re: Hoppin's Robots that are IronForge
Post by: Reier on March 04, 2018, 05:42:07 PM
what's the armor? hope its a lot cause im not sure where all the weight went if it isnt

for future reference, firebirds+slimmer wheels > slim drive with thick wheels. it's about the same weight and a lot more powerful.

looks solid all in all